EU’s first truck CO2 standards: industry urges national governments to adopt viable approach
Brussels, 7 December 2018 – In the run up to the Council meeting later this month where the 28 member states are expected to adopt their position on the EU’s first CO2 standards for trucks, the European Automobile Manufacturers’ Association (ACEA) is calling on governments to adopt a well-balanced and viable approach to this piece of legislation, which will have a huge impact on the future of the heavy-duty vehicle industry.
“There is no doubt that climate change is a fundamental challenge, requiring efforts to cut CO2 emissions from all sectors. The EU truck industry is fully committed to play its part,” said Joachim Drees, CEO of MAN Truck & Bus and Chairman of ACEA’s Commercial Vehicle Board of Directors, at a press conference in Brussels.
“To this end, we urge member states to ensure that the right framework conditions are in place for this regulation. Providing the necessary recharging infrastructure, as well as incentives for early investments in new technologies and effective support for the market penetration of zero- and low-emission trucks will be key prerequisites to deliver on ambitious CO2 targets, and to encourage our customers to buy cleaner vehicles.”
The CO2 reduction levels proposed by the European Commission in May – minus 15% in 2025 and minus 30% in 2030 – set a path towards reaching the Paris Climate Agreement objectives. However, these levels are highly ambitious and will require a rapid and large-scale deployment of new powertrain technologies – many of which are not yet readily available for widespread market introduction.
“While using electrical power for a delivery truck operating in urban environments can make sense, a scenario where electric is the right choice for long-haul operations across Europe is much less likely in the mid-term, or even in the long run,” stated Mr Drees.
“Whatever the vehicle segment – long-haul, regional or urban delivery – a stronger market uptake of alternatively-powered trucks requires some basic conditions to be in place, many of which are outside the control of our industry and still lacking today.” These include adequate investments in charging and refuelling infrastructure, as well as rapid fleet renewal by transport operators.
ACEA supports the European Commission’s idea of introducing specific incentives to stimulate innovation and the uptake of alternatively-powered trucks (the so-called ‘super-credit’ system). However, it is very concerned that this could be adapted to include a ‘malus’, which would penalise manufacturers who do not sell a mandatory quota of zero- and low-emission trucks.
Drees: “Given the obstacles zero-emission trucks currently face – lack of infrastructure, loss of payload, limited range, higher costs – it will not be easy to convince customers to buy these trucks. Policy makers need to be aware that forcing manufacturers to provide a certain supply of zero-emission vehicles when there is insufficient market demand would be extremely risky for Europe’s truck industry.”
Another concern ACEA has is that the proposals on the table also include massive penalties for manufacturers who are unable to reach the targets. “We are not at all against the principle of paying penalties in case of excess CO2 emissions,” Drees explained. “But we are concerned about the disproportionate amounts being proposed.” Based on these, a truck manufacturer that exceeds its target by just one gramme of CO2 would have to pay hundreds of millions of euros.
The industry is ready to further drive down CO2 reductions from trucks, but calls on policy makers to strike the right balance between environmental objectives and the sector’s competitiveness when finalising this regulation.
Notes for editors
- The European Commission published its proposal on future CO2 standards for new heavy-duty vehicles in May 2018.
- In November, the European Parliament voted on this file.
- The next step is for member states to adopt their common position, so that trilogue negotiations can commence. This is expected to happen at the Environment Council meeting of 20 December.
- The European Automobile Manufacturers’ Association (ACEA) is the Brussels-based trade association of the 16 major car, van, truck and bus producers in Europe.
- The ACEA commercial vehicle members are DAF Trucks, Daimler Truck, Ford Trucks, Iveco Group, MAN Truck & Bus, Scania, Volkswagen Commercial Vehicles, and Volvo Group.
- Visit www.acea.auto for more information about ACEA, and follow us on www.twitter.com/ACEA_auto or www.linkedin.com/company/ACEA/.
- Contact: Cara McLaughlin, Communications Director, email@example.com, +32 485 88 66 47.
Interested in ACEA press releases?
Receive them directly in your inbox!
About the EU automobile industry
- 13 million Europeans work in the auto industry (directly and indirectly), accounting for 7% of all EU jobs.
- 11.5% of EU manufacturing jobs – some 3.4 million – are in the automotive sector.
- Motor vehicles are responsible for €374.6 billion of tax revenue for governments across key European markets.
- The automobile industry generates a trade surplus of €79.5 billion for the EU.
- The turnover generated by the auto industry represents more than 8% of the EU’s GDP.
- Investing €58.8 billion in R&D annually, the automotive sector is Europe’s largest private contributor to innovation, accounting for 32% of total EU spending.